Maytag Bravos Xl Mct Washer Won T Start

I have a mct bravo xl and it won t start a new load it is stuck on deep water and won t start.

Maytag bravos xl mct washer won t start.

I set it up on blocks so i can see under it and looks to be coming from the basket underneath when th. If the washer starts and seems to progress through the cycle well but doesn t move to the spin cycle the problem may be with the locking lid switch. A bad lid switch will make it so power cannot get to the drive motor. Water level switch the water level switch aka pressure switch controls the water level.

Check your owner s manual for information on your specific model. The washer has attempted to fill and begin a wash cycle. If the fu se does not have continuity replace it. If the line fuse blows the washer won t start.

Other problems include stopping at mid cycle loud noise and failure to drain and spin. Timer the timer supplies power to turn the motor. I have a maytag bravos washer mtw6600tq0 that won t start. If the washer is overloaded it will drain any water and detergent that was added during the fill.

Close lid and press start. If the timer is defective the motor will not turn therefore no washer agitation. To determine if the thermal fuse is at fault use a multimeter to test it for continuity. Depending on your model some washers may fill without the lid locking and others will not even start until the lid locks.

The lid must be completely closed and latched for the washer to operate. To correct the overload remove several items and add detergent. Maytag bravos washer will not continue to the next cycle after the wash cycle. The maytag bravos washers come in different models with each model experiencing unique problems.

I have a maytag bravos xl washer that is leaking water. In addition you should investigate and resolve the problem that caused the fuse to blow. Common problems with maytag bravos washers include failure to start water filling slowly water leakage failure of the door or lid to lock and overflowing.