Select drain spin to remove any water remaining in the washer.
Maxima x steam washer door locked.
While this option is on the fan blows and the load is tumbled periodically for up to 12 hours.
Wait approximately 2 minutes for control to reset.
There was an answered by a verified appliance technician.
Replace the door lock switch if defective.
If the washer was powered on before being connected to water the door may be locked and it may go into a drain mode.
The safety lock is designed to prevent people from opening the door when the water level or interior temperature inside the drum is too high.
When using one of these cycles the door will remain locked until the cancel button is pushed.
The washer door will unlock at the end of the drain.
If the washing machine malfunctions or you need to stop the cycle and retrieve the clothing you can force the door to unlock.
Water remaining in washer after cycle.
Our maytag maxima steam washer has a flashing yellow light next to door locked the door won t open and the machined cannot be turned on.
You may also see an f8 e1 error code.
If the washer will not unlock at the end of a wash cycle unplug the washer or disconnect power.
Disconnect the washing machine from the mains grid and inspect the door lock unit for any possible damage.
Unplug the washer and check the door lock assembly for damage or a loose wiring connection.
The code goes on in case your washer cannot lock the door.
This is a guide about unlocking the door on a maytag front load washer.
My maytag maxima steam washer door is locked and will not open.
You may also want to test all wiring connections leading to the lock.
Front loaders have a locking mechanism to avoid opening the door during a washing cycle but occasionally this lock will be activated accidentally.
The control lock light is on as well.
Reconnect power to washer plug in.
Fresh hold option is on.
The door can t lock.
We use cookies to give you the best possible experience on our website.
If the washer has an f8 e1 error or lo fl error the door will be locked and the control will be unresponsive.
Clear any debris out of the door lock assembly.